The pilot light can be blown by a gentle breeze in some furnace systems, leaving a house without any source of warmth when the thermostat is turned up. You may not want to call professionals for problems related to heating service in Sacramento. Fortunately, learning how to light a furnace pilot light is easy.
Steps To Safely Light A Pilot Light In A Furnace
In this blog, we’ll go through the fundamentals of re-lighting a gas furnace’s pilot light.
-
You Can Find The Instructions Label On Your Furnace
Every furnace should include a label that instructs you on how to light it. However, the printing may be too small at times, or the furnace area may be too dark. The label may be difficult to read in some instances. The work will be considerably easier if you keep the following instructions near your furnace or in another safe place where they may be easily found.
-
Locate Pilot Lights And Components
A switch near the bottom of your furnace usually says “Pilot,” “On,” and “Off.” Locate this switch and flip it to the “Off” position. Wait at least five minutes before proceeding. This is significant because it allows the gas to disperse, which is required to avoid fire. While you’re waiting, note where the reset button is, which should be close to the dial you just switched off.
-
Reactivate The Pilot Light
Turn the knob to “Pilot” after the gas has dissipated. Then press and hold the “Reset” button while bringing a lighter’s flame close to the pilot light opening. This should light the pilot light on the furnace. Once you’re certain the pilot light is turned on, let go of the reset button.
To get you started, some important points are mentioned below that will walk you through the procedure of re-lighting a pilot light and you can avoid calling professionals for HVAC in Sacramento, CA.
Things To Remember
Here are some things to keep in mind when re-lighting your furnace pilot light.
- If you have followed the above methods for lighting a furnace more than twice and the pilot light still does not ignite or does not stay lit when you press the “Reset” button, there is a problem with the furnace, and you should contact a furnace professional.
- Never turn on a furnace without first shutting it off. Excess gas can cause major damage to the home as well as injuries.
- Other than the pilot light, do not attempt to repair your furnace unless you are experienced in furnace repair. While the furnace itself is rather safe, gas can be hazardous.
- Instead of using the long match or lighter, you can place some distance between yourself and the ignited pilot light by rolling a piece of paper firmly around your hand.
The ability to light the furnace pilot light isn’t something you’ll need very often, but it’s a skill you’ll want to have just in case. You should have no trouble lighting a furnace as long as you follow the guidelines, and your home will be warm and toasty in no time.
Some furnace issues are more complicated than a do-it-yourself remedy. If you need to replace your home heating system, you can call an HVAC professional for furnace repair in Sacramento.